YASKAWA NX100 - Table of Contents

Reg.No. ME00107EN-02 Page 3
Fieldbus PCI-Card
Contents
1 General............................................................................................................................ 7
1.1 About this manual ..................................................................................................... 7
1.1.1 Copyright ................................................................................................................. 7
1.2 System requirements................................................................................................ 7
1.2.1 NX100 Software ...................................................................................................... 7
1.2.2 DX100/DX200 software........................................................................................... 7
1.3 In manual included Fieldbus PCI-cards and NetTools........................................... 7
1.4 Safety.......................................................................................................................... 8
1.5 Handling ESD sensitive devices.............................................................................. 9
1.6 Manufacturer.............................................................................................................. 9
1.7 Introduction ............................................................................................................... 9
1.8 Terms........................................................................................................................ 10
1.9 Fieldbus systems .................................................................................................... 10
1.10 Introduction to the fieldbus PCI-cards .................................................................. 10
1.11 Hardware compatibility........................................................................................... 10
2 Installation...................................................................................................................11
2.1 General......................................................................................................................11
2.1.1 Specification ...........................................................................................................11
2.1.2 Technical specification............................................................................................11
2.1.3 Compliances and conformances............................................................................11
2.2 Hardware installation...............................................................................................11
2.2.1 NX100 Installation ................................................................................................. 12
2.2.2 DX100/DX200 Installation ..................................................................................... 12
3 Software configuration...........................................................................................15
3.1 Settings .................................................................................................................... 15
3.2 Manual I/O allocation (FD 134) ............................................................................... 19
3.3 I/O map ..................................................................................................................... 20
3.3.1 Fieldbus input data map ........................................................................................ 20
3.3.2 Fieldbus output data map ...................................................................................... 20
3.4 Fieldbus status byte................................................................................................ 21
4 General installation in IP-based networks.......................................................22
4.1 Ping .......................................................................................................................... 22
4.1.1 No answer from ping.............................................................................................. 22
4.1.2 Only one Ethernet cable used ............................................................................... 22
4.1.3 Logical Networks ................................................................................................... 22
4.2 Anybus IPconfig...................................................................................................... 23
4.2.1 The module is not shown....................................................................................... 24
4.2.2 The module has IP address 0.0.0.0....................................................................... 25