User Guide for SIP VP-T49G IP Phone
252
Intercom Barge
You can enable or disable the phone to automatically answer an incoming intercom call while
there is already an active call on the phone. If Intercom Barge is enabled, the phone will
automatically answer the intercom call and place the active call on hold. If Intercom Barge is
disabled, the phone will handle an incoming intercom call like a waiting call. Intercom Barge is
disabled by default.
Note
To configure intercom features via phone user interface:
1. Tap ->Features->Intercom.
2. Make the desired changes.
3. Tap the Save soft key to accept the change or to cancel.
These specific parameters are configurable via web user interface at the path
Features->Intercom.
Using Intercom
To place an intercom call when the target phone is idle:
1. Tap the intercom key when the phone is idle.
The called destination plays a warning tone and automatically answers the call in the
speakerphone mode by default.
2. To end the intercom call, tap the intercom key again or the EndCall soft key.
To enable the phone to receive a new incoming call when it has an active call, make sure that call
waiting feature is enabled on the phone in advance. For more information, refer to Call Waiting
To Next Page
Loading...
Need help?
General
