Overview
25
The phone receives an audio-only call.
The phone receives a video call.
There is an active video call.
The video call is muted.
The video call is held.
The shutter switch is open, but the near-site video is
stopped transmitting during a video call.
The video call is placed on hold.
The phone is powered off.
The camera is not properly connected to the phone.
The shutter switch is closed.
User Interfaces
Two ways to customize configurations of your SIP VP-T49G IP phone:
The user interface on the IP phone.
The user interface in a web browser on your PC.
The hardware components keypad and touch screen constitute the phone user interface, which
allows the user to execute all call operation tasks and basic configuration changes directly on
the phone. In addition, you can use the web user interface to access all configuration settings. In
many cases, it is possible to use either the phone user interface and/or the web user interface
interchangeably. However, in some cases, it is only possible to use one or the other interface to
operate the phone and change settings.
Phone User Interface
You can customize your phone by tapping to access the phone user interface. The
Advanced option is only accessible to the administrator, and the default administrator
password is “admin” (case-sensitive). For more information on customizing your phone with the
available options from the phone user interface, refer to Customizing Your Phone on page 63.
Note
Web User Interface
In addition to the phone user interface, you can also customize your phone via web user
interface. In order to access the web user interface, you need to know the IP address of your
new phone. To obtain the IP address, tap ->Status on the phone when the phone is idle.
For a better understanding of the menu structure, please refer to Appendix B – Menu Structure
on page 313.
To Next Page
Loading...
Need help?
General
