User Guide for SIP VP-T49G IP Phone
160
Placing Calls
You can dial using the phone number/SIP URI/IP address/name (User Name for SIP account,
H.323 Name for H.323 account). The maximum SIP URI length is 32 characters. For example, SIP
URI: 3606@sip.com. For more information on IP call, refer to Direct IP Call on page 297. The
following describes how to place a call using the phone number.
You can place a call in one of three ways using your SIP VP-T49G IP phone:
- Using the handset
- Using the speakerphone
- Using the headset
You can also dial the number first, and then choose the way you want to speak to the other
party.
Note
You can also dial an entry/contact from call history, local directory or remote phone book. For
more information, refer to Contact Management on page 87 and Call History Management on
page 111.
By default, you can set up a video call with the other party that is video-enabled. The IP phone
can set up video calls with only two parties (even if more than two parties that set up a call with
you can send video). To place an audio-only call, make sure the video feature is disabled. For
more information, refer to Changing the Video Settings on page 172.
During a call, you can alternate between Speakerphone, Headset, and Handset modes by
pressing the Speakerphone key, the HEADSET key, or by picking up the handset.
If you want to place a call to a Yealink Cloud contact who is in the same enterprise directory as
you, you can enter the extension (the last four Cloud number). If you want to place a call to a
Cloud contact who is in different enterprise directory from you, you should enter 9-digit Cloud
To Next Page
Loading...
Need help?
General
