User Guide for SIP VP-T49G IP Phone
52
You can configure a static IPv6 address for the IP phone. Before configuring it, make sure
that the IP mode is configured as IPv6 or IPv4 & IPv6.
To configure a static IPv6 address via phone user interface:
1. Tap ->Advanced (default password: admin) ->Network->WAN Port->IPv6.
2. Tap the Type field.
3. Tap Static IP in the pop-up dialog box.
4. Enter the desired value in the IP, IPv6 IP Prefix, Gateway, Primary DNS and Secondary
DNS field respectively.
5. Tap the Save soft key to accept the change or to cancel.
If you are using an xDSL modem for IPv4 network connection, you can connect your phone to
the Internet via PPPoE mode. Set the WAN port as a PPPoE port. The PPPoE port will perform a
PPP negotiation to obtain the IP address. Contact your system administrator for the PPPoE user
name and password.
To configure PPPoE via phone user interface:
1. Tap ->Advanced (default password: admin) ->Network->WAN Port->IPv4.
2. Tap the Type field.
3. Tap PPPoE in the pop-up dialog box.
To Next Page
Loading...
Need help?
General
