Yeastar Technology TG100 - Set up a Mobile to IP Route (Account Mode)

TG100 User Guide
20/75
g. Click Save and Apply Changes.
2. Use the VoIP account to register a VoIP trunk on your PBX.
3. Go to Status > System Status > Trunk Status to check the account status on
TG gateway.
If the account status shows , then the TG gateway and your PBX are
connected.
Set up a Mobile to IP Route (Account Mode)
Procedure
1. Navigate to Gateway > Routes Settings > Mobile to IP.
2. Click Add Mobile to IP Route.
3. Enter a name in the Route Name field.
4. Choose the GSM/3G trunk from Call Source field.
5. Choose a SIP account or a trunk group from the Call Destination field.
DTMF Mode
RFC2833, Info, Inband, Auto.
Enable IP
Restriction
If this option is enabled, only the allowed IP addresses can
register the account number. In this way, VoIP security can be
enhanced.