Yeastar Technology TG100 User Manual

TG100 User Guide
62/75
Configure IAX Settings
IAX is the Internal Asterisk Exchange protocol, you can connect to TG100 or register
IAX trunk to another IAX server. It’s supported by the asterisk-based IPPBX.
It is wise to keep the default settings provided on the system. However, for a few
settings, you need to change them to suit your situation.
Navigate to Gateway > VoIP Settings > IAX Settings, configure the IAX general
settings.
Check the description of IAX settings below.
Option
Description
UDP Port
Port used for IAX2 registrations. The default port is 4569.
Bandwidth
Control which codec will be used.
 Low
 Medium
 High
Min
Registration/Subscripti
on Time
Minimum duration (in seconds) of an IAX2 registration. The
default value is 60.
Max
Registration/Substripti
on Time
Maximum duration (in seconds) of an IAX2 registration. The
default value is 1200.
Codecs
Enable the codec for IAX communication.
 u-law
 a-law
 GSM
 SPEEX
 G726
 ADPCM
 G729A
Session-timers
Enable session-timer mode. The default value is “Accept”.
Note: Disable this option if you find call be cut off every 15 minutes.
Session-expires
The max refresh interval.
Session-minse
The min refresh interval, which can not be shorter than 90s.
Session-refresher
Choose session-refresher. The default value is Uas.
 Uas
 Uac

Yeastar Technology TG100 Specifications

General

Brand	Yeastar Technology
Model	TG100
Category	Gateway
Language	English