TG100 User Guide
28/75
If the status of the two peer trunks both indicates connected, then the TG gateway
and your PBX are connected.
Set up a Mobile to IP Route (Peer Trunk Mode)
Procedure
1. Navigate to Gateway > Routes Settings > Mobile to IP.
2. Click Add Mobile to IP Route.
3. Enter a name in the Route Name field.
4. Choose the GSM/3G trunk from Call Source field.
5. Choose a service provider trunk or a trunk group from the Call Destination field.
6. (Optional) Set the Hotline number.
If you set hotline to a PBX extension number, the incoming call will be
routed to the extension directly.
If you set the hotline to the DID number of PBX’s inbound route, the call
will be routed to the destination of the inbound route.
Note: If you don’t set a hotline number, you need a two-stage dial to reach the
destination number.
a. Set Simple Mode to No.
b. Set Two Stage Dial to Yes.
7. Click Save and Apply Changes.
When a call reaches the selected GSM/3G trunk, the call will be routed to the
To Next Page
Loading...
Need help?
General
