YOKOGAWA DL 1540 User Manual

IM 701510-01E
14-4
14.4 Adjusting the Printer Density
1. Press the MISC key to display the MISC menu.
2. Press the “Config...” soft key.
3. Press the SELECT key to display the density setting frame.
4. Use the rotary knob to select the desired density level. Pressing the
RESET key results in displaying the default value.
5. Press either the SELECT key or the ESC key to close the density
setting frame.
Explanation
Setting the printer density: Printer Density
This setting controls the printing density of hard copies on the built-in printer.
Setting range : 0 to 3
Default setting : 1
Note
When you press the soft key [Config...] on DL1540L, or DL1540 with a software (ROM) version of 1.10
or later, the setting menu for the isolator (700926) will appear as well. For details regarding the isolator
and its operation, refer to the accessory user’s manual of the isolator.
Keys and Procedure
MISC key
Soft keys
Rotary knob
ESC key
SELECT key
RESET key

YOKOGAWA DL 1540 Specifications

General

Brand	YOKOGAWA
Model	DL 1540
Category	Test Equipment
Language	English