6-14
IM 701510-01E
6.9 Setting the Action-On Trigger
1. Press the SHIFT + MODE (ACTION) key to display the trigger on
action selection menu.
2. Press the soft key corresponding to the desired action. Data acquisition
will stop.
3. In case you selected “FD(P-P)” or “FD(ACQ)”, pressing the
“FileName” soft key will display the keyboard. In case you selected
“PRINTER”, skip step 4.
4. Use the keyboard to enter the filename. For details on entering
characters using the keyboard, refer to page 4-8.
Starting the action on trigger
5. Press the “EXEC” soft key to restart acquisition. The selected action
will be validated when a trigger is activated.
or
Stopping the action on trigger
6. Press the “ABORT” soft key to stop acquisition.
or
Explanation
Selecting the action-on trigger
The action can be selected from the following.
PRINTER Outputs hardcopy to the built-in printer.
FD(P-P) Saves all the displayed waveforms (as P-P compressed data) on a floppy disk
when a trigger is activated.
FD(ACQ) Saves all the displayed acquisition data (binary data) on a floppy disk when a
trigger is activated.
When the action on trigger starts, the trigger mode will change automatically to the single
short mode or single mode.
Specifying a file name when “FD(P-P)” or “FD(ACQ)” has been selected as the
trigger action
A file No. (starting from “0001”) is assigned to each waveform data automatically when the
data is saved on a floppy disk. It is possible to insert a common file name (character string
consisting of up to four characters) before the assigned file No. (for instance,
“TRGO0001”).
The entered file name is reset when “ABORT” is selected.
Keys and Procedure
MODE(ACTION) key
Soft keys
START/STOP key
SHIFT key
To Next Page
Loading...
Need help?
General
