EasyManuals Logo

Zebra Z4Mplus User Manual

Zebra Z4Mplus
178 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #132 background imageLoading...
Page #132 background image
102 Z4Mplus and Z6Mplus User Guide
Troubleshooting
LCD Error Conditions and Warnings
Warning — CUTTER JAM
OUT OF MEMORY*
Caution • Cutter blade is sharp. Use caution when cleaning. Do not rub the blade
with your fingers.
Problem Solution
Cutter blade is in the media
path.
Turn off the printer power and unplug the
printer. Inspect the cutter module for debris
and clean as needed following the cleaning
instructions on page 93.
Problem Solution
*There is not enough memory to
perform the function shown on
the second line of the error
message.
Insufficient DRAM for the label length,
downloaded fonts/graphics, and images.
Ensure that the device, such as FLASH
memory or PCMCIA card, is installed and
not write protected or full.
Ensure that the data is not directed to a
device that is not installed or available.

Table of Contents

Other manuals for Zebra Z4Mplus

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Zebra Z4Mplus and is the answer not in the manual?

Zebra Z4Mplus Specifications

General IconGeneral
Print MethodThermal transfer or direct thermal
Resolution203 dpi
Max Print Width4.09 inches
Max Print Length39 inches
Max Print Speed10 inches per second
Memory4 MB Flash, 8 MB DRAM
InterfaceParallel, Serial
Media SensorsReflective and transmissive
Media Width0.79 inches to 4.5 inches
Media Length0.38" (9.6 mm) to 39" (991 mm)
Ribbon Width2 inches to 4.33 inches
Power Requirements100-240 VAC, 50/60 Hz
Operating Temperature40°F to 105°F
Storage Temperature-40 to 140°F (-40 to 60°C)
Humidity20 to 85% non-condensing

Related product manuals