Zebra Z4Mplus User Manual

112 Z4Mplus and Z6Mplus User Guide
Troubleshooting
Printer Diagnostics
Communications Diagnostics Test
This test is controlled from the front panel display. See page 75. A typical printout
from this test is shown in below. Turn the printer Off (O) to exit this self test.
Loading Factory Defaults
Perform the following procedure to load the factory defaults:
1. Press SETUP/EXIT two times.
2. Use PLUS (+) or MINUS (–) to scroll through the SAVE CHANGES choices.
3. When LOAD DEFAULTS displays, press SETUP/EXIT.
Note • This label is inverted when printed (prints upside down).

Zebra Z4Mplus Specifications

General

Print Method	Thermal transfer or direct thermal
Resolution	203 dpi
Max Print Width	4.09 inches
Max Print Length	39 inches
Max Print Speed	10 inches per second
Memory	4 MB Flash, 8 MB DRAM
Interface	Parallel, Serial
Media Sensors	Reflective and transmissive
Media Width	0.79 inches to 4.5 inches
Media Length	0.38" (9.6 mm) to 39" (991 mm)
Ribbon Width	2 inches to 4.33 inches
Power Requirements	100-240 VAC, 50/60 Hz
Operating Temperature	40°F to 105°F
Storage Temperature	-40 to 140°F (-40 to 60°C)
Humidity	20 to 85% non-condensing