Zebra Z4Mplus User Manual

Printer Basics
Printer Overview
Z4Mplus and Z6Mplus User Guide 37
Front Panel Lights
Light Status Indication
POWER Off The printer is off or no power is applied.
On The printer is on.
PAUSE Off Normal printer operation.
On The printer has stopped all printing operations.
Flashing Peel-Off Mode, the Pause light flashes when the
label is available, and when initializing FLASH
or PCMCIA memory.
ERROR Off Normal printer operation (no errors).
Slow
flashing
RIBBON IN warning, HEAD UNDER TEMP
warning, or HEAD OVER TEMP error.
Fast flashing HEAD OPEN error.
On PAPER OUT, RIBBON OUT, or CUTTER JAM
errors.
DATA Off Normal printer operation (no data being received
or processed).
One flash CANCEL is pressed and a format is successfully
cancelled.
Slow
flashing
The printer is unable to accept more data from
the host.
Fast flashing The printer is receiving data.
On A partial format has been received and no
subsequent data activity.

Zebra Z4Mplus Specifications

General

Print Method	Thermal transfer or direct thermal
Resolution	203 dpi
Max Print Width	4.09 inches
Max Print Length	39 inches
Max Print Speed	10 inches per second
Memory	4 MB Flash, 8 MB DRAM
Interface	Parallel, Serial
Media Sensors	Reflective and transmissive
Media Width	0.79 inches to 4.5 inches
Media Length	0.38" (9.6 mm) to 39" (991 mm)
Ribbon Width	2 inches to 4.33 inches
Power Requirements	100-240 VAC, 50/60 Hz
Operating Temperature	40°F to 105°F
Storage Temperature	-40 to 140°F (-40 to 60°C)
Humidity	20 to 85% non-condensing