Zebra Z4Mplus User Manual

Printer Setup
Troubleshoot Printing Problems
Z4Mplus and Z6Mplus User Guide 21
Troubleshoot Printing Problems
If the configuration label did not print, or if the labels are aligned properly, review the
items below in the order shown. Do only as many steps as needed to solve the printing
problem.
• Review Types of Media on page 10.
• Review Load the Media on page 13.
• Configure the printer according to the directions given in Basic Configuration on
page 22.
• Check the position of the media sensor and move if necessary. Follow the
directions in Position the Label Sensor on page 26.

Zebra Z4Mplus Specifications

General

Print Method	Thermal transfer or direct thermal
Resolution	203 dpi
Max Print Width	4.09 inches
Max Print Length	39 inches
Max Print Speed	10 inches per second
Memory	4 MB Flash, 8 MB DRAM
Interface	Parallel, Serial
Media Sensors	Reflective and transmissive
Media Width	0.79 inches to 4.5 inches
Media Length	0.38" (9.6 mm) to 39" (991 mm)
Ribbon Width	2 inches to 4.33 inches
Power Requirements	100-240 VAC, 50/60 Hz
Operating Temperature	40°F to 105°F
Storage Temperature	-40 to 140°F (-40 to 60°C)
Humidity	20 to 85% non-condensing