Zebra Z4Mplus - Remove the Ribbon

56 Z4Mplus and Z6Mplus User Guide
Printer Basics
Load the Ribbon
Remove the Ribbon
1. If the ribbon has not run out, break it between the strip plate and the ribbon take-up
spindle.
2. While turning the ribbon take-up spindle release knob counter clockwise, squeeze
the ribbon against the ribbon take-up spindle tension blades.
3. When the tension blades collapse into the ribbon take-up spindle, hold the release
knob and rotate the spent ribbon toward the rear of the printer. Then, slide off the
ribbon.
Note • Do not cut the ribbon on the ribbon take-up spindle. This may damage the
spindle.