Zebra Z4Mplus User Manual

36 Z4Mplus and Z6Mplus User Guide
Printer Basics
Printer Overview
Front Panel Keys
Key Function
FEED Forces the printer to feed one blank label each time the key is
pressed.
Printer not printing: one blank label immediately feeds.
Printing: one blank label feeds after the current batch of labels
is complete.
PAUSE Starts and stops the printing process.
Printer not printing: no printing occurs. (Press PAUSE again to
resume printing.)
Printing: printing stops after the current label is complete.
CANCEL Cancels print jobs when in the pause mode.
Printer not printing: the next stored label format does not print.
Printing: current label completes printing and the next label
format is cancelled.
Press and hold for several seconds to cancel all print jobs in
memory.
SETUP/EXIT Enters and exits the configuration mode.
SELECT Toggles the function of PLUS (+) and MINUS (–) between the
Scroll and Change Modes.
Press once to use PLUS (+) and MINUS (–) to change the
values of the selection.
Press again to use PLUS (+) and MINUS (–) to scroll through
the menu items.
PLUS (+)
(scroll mode)
Scrolls to the next selection.
PLUS (+)
(change mode)
Increases the value.
Answers yes.
Prints a label (when applicable).
MINUS (–)
(scroll mode)
Scrolls to the previous selection.
MINUS (–)
(change mode)
Decreases the value.
Selects the digit you wish to change.
Answers no.

Zebra Z4Mplus Specifications

General

Print Method	Thermal transfer or direct thermal
Resolution	203 dpi
Max Print Width	4.09 inches
Max Print Length	39 inches
Max Print Speed	10 inches per second
Memory	4 MB Flash, 8 MB DRAM
Interface	Parallel, Serial
Media Sensors	Reflective and transmissive
Media Width	0.79 inches to 4.5 inches
Media Length	0.38" (9.6 mm) to 39" (991 mm)
Ribbon Width	2 inches to 4.33 inches
Power Requirements	100-240 VAC, 50/60 Hz
Operating Temperature	40°F to 105°F
Storage Temperature	-40 to 140°F (-40 to 60°C)
Humidity	20 to 85% non-condensing