Zebra Z4Mplus User Manual

Printer Setup
Before You Begin
Z4Mplus and Z6Mplus User Guide 9
Ribbon
Ribbon is a thin film carrying wax or wax resin that is transferred to the media during
the thermal transfer process. Direct thermal media does not require the use of a ribbon,
but printhead life may be shortened because of the abrasion of direct contact with the
media.
Printhead life may be reduced by the abrasion from exposed paper fibers when using
perforated media. Refer to Printer Basics on page 33 for a detailed description of
loading label media and ribbon.
Caution • The ribbon must be as wide or wider than the media being used. If the
ribbon is narrower than the media, areas of the printhead are unprotected and subject
to premature wear.
Note • When printing in direct thermal mode, ribbon is not used and should not be
loaded into the printer.

Zebra Z4Mplus Specifications

General

Print Method	Thermal transfer or direct thermal
Resolution	203 dpi
Max Print Width	4.09 inches
Max Print Length	39 inches
Max Print Speed	10 inches per second
Memory	4 MB Flash, 8 MB DRAM
Interface	Parallel, Serial
Media Sensors	Reflective and transmissive
Media Width	0.79 inches to 4.5 inches
Media Length	0.38" (9.6 mm) to 39" (991 mm)
Ribbon Width	2 inches to 4.33 inches
Power Requirements	100-240 VAC, 50/60 Hz
Operating Temperature	40°F to 105°F
Storage Temperature	-40 to 140°F (-40 to 60°C)
Humidity	20 to 85% non-condensing