Zebra Z4Mplus User Manual

10 Z4Mplus and Z6Mplus User Guide
Printer Setup
Before You Begin
Types of Media
The following is a description of the various types of media approved for use in the
Z4Mplus and Z6Mplus printers.
Non-Continuous Web Media
Non-continuous web media (shown below) refers to individual labels separated by a
gap, notch, or hole. When you look at the media, you can tell where one label ends and
the next one begins. The illustration below shows samples of all three. The
noncontinuous with gaps, is individual labels on a continuous liner.
Number Description
1
Hole
2
Notch
3
Label Gap
1
2
3
3

Zebra Z4Mplus Specifications

General

Print Method	Thermal transfer or direct thermal
Resolution	203 dpi
Max Print Width	4.09 inches
Max Print Length	39 inches
Max Print Speed	10 inches per second
Memory	4 MB Flash, 8 MB DRAM
Interface	Parallel, Serial
Media Sensors	Reflective and transmissive
Media Width	0.79 inches to 4.5 inches
Media Length	0.38" (9.6 mm) to 39" (991 mm)
Ribbon Width	2 inches to 4.33 inches
Power Requirements	100-240 VAC, 50/60 Hz
Operating Temperature	40°F to 105°F
Storage Temperature	-40 to 140°F (-40 to 60°C)
Humidity	20 to 85% non-condensing