Zebra Z4Mplus User Manual

116 Z4Mplus and Z6Mplus User Guide
Specifications
Media Specifications
Media Specifications
Media Specifications Z4Mplus Z6Mplus
Label length Minimum Tear-off 0.5 in. 13 mm 0.5 in. 13 mm
Peel-off 1 in. 25.4 mm 1 in. 25.4 mm
Rewind 0.5 in. 13 mm 0.5 in. 13 mm
Cutter 1 in. 25.4 mm 1.5 in. 38.1 mm
Maximum 39 in. 991 mm 39 in. 991 mm
Label width Minimum 1 in. 25.4 mm 2 in. 51 mm
Maximum Tear/Cutter 4.5 in. 114 mm 7.0 in. 178 mm
Peel/
Rewind
4.25 in. 108 mm 6.75 in. 171 mm
Total thickness (includes
liner, if any)
Minimum 0.0023 in. 0.058 mm 0.0023 in. 0.058 mm
Maximum 0.010 in. 0.25 mm 0.010 in. 0.25 mm
Core size 3 in. 76 mm 3 in. 76 mm
Maximum roll diameter 8 in. 203 mm 8 in. 203 mm
Inter-label gap Minimum 0.079 in. 2 mm 0.079 in. 2 mm
Preferred 0.118 in. 3 mm 0.118 in. 3 mm
Maximum 0.157 in. 4 mm 0.157 in. 4 mm
Ticket/tag notch size (width x length) 0.236 in. ×
0.12 in.
6 mm × 3 mm 0.236 in. ×
0.12 in.
6 mm ×
3mm
Hole diameter 0.125 in. 3 mm 0.125 in. 3 mm
Notch or hole position
(Centered from inner
media edge)
Minimum 0.15 in. 3.8 mm 0.15 in. 3.8
Maximum 2.25 in. 57 mm 3.5 in. 90 mm

Zebra Z4Mplus Specifications

General

Print Method	Thermal transfer or direct thermal
Resolution	203 dpi
Max Print Width	4.09 inches
Max Print Length	39 inches
Max Print Speed	10 inches per second
Memory	4 MB Flash, 8 MB DRAM
Interface	Parallel, Serial
Media Sensors	Reflective and transmissive
Media Width	0.79 inches to 4.5 inches
Media Length	0.38" (9.6 mm) to 39" (991 mm)
Ribbon Width	2 inches to 4.33 inches
Power Requirements	100-240 VAC, 50/60 Hz
Operating Temperature	40°F to 105°F
Storage Temperature	-40 to 140°F (-40 to 60°C)
Humidity	20 to 85% non-condensing