EasyManuals Logo

Zebra Z4Mplus User Manual

Zebra Z4Mplus
178 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #172 background imageLoading...
Page #172 background image
142 Z4Mplus and Z6Mplus User Guide
Extend Printhead Life
Extend the Life of Your Printhead with Save-a-Printhead Cleaning Film
Ribbon Backcoating and Buildup: Printhead contamination from direct thermal
labels or thermal transfer ribbon may occur in applications requiring high burn
settings, high head pressure, high speed, or high volume. This contamination builds up
on the printhead elements, creating a barrier to the heat transformation required to
produce high-quality images. Contaminant buildup occurs gradually and results in
poor print quality that may look like faded print or a failed print element. This buildup
resists cleaning with presoaked swabs and can be difficult to remove. Follow the
recommendations below to avoid contamination buildup on the printhead.
To avoid ribbon backcoating and buildup:
Use thermal transfer ribbons that have been specially cured to provide backcoat
protection for high-demand applications. These ribbons (sometimes referred to as
anti-stick ribbons) also dissipate static and provide more lubrication.
Follow the recommended Printhead Preventive Maintenance procedures.
Use Zebra’s Save-a-Printhead cleaning film to remove printhead contamination
buildup quickly and easily.
Save-a-Printhead
Cleaning Film
Save-a-Printhead cleaning film is a specially coated film that removes contamination
buildup without damaging the printhead. Save-a-Printhead cleaning film extends the
life of your printhead, reduces maintenance downtime and the cost of replacing a
printhead, and is an inexpensive, easy, and quick way to remove contaminants without
removing the printhead.
Use Save-a-Printhead cleaning film when you see degrading print quality that looks
like faded print or a failed print element that cannot be corrected by cleaning with the
presoaked cleaning swabs.
For 200 and 300 dpi printers: Clean after every roll (1500 feet or 450 m) of thermal
transfer ribbon or after every roll (500 feet or 150 m) of direct thermal labels or when
CLEAN HEAD NOW appears on the liquid crystal display (LCD).

Table of Contents

Other manuals for Zebra Z4Mplus

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Zebra Z4Mplus and is the answer not in the manual?

Zebra Z4Mplus Specifications

General IconGeneral
Print MethodThermal transfer or direct thermal
Resolution203 dpi
Max Print Width4.09 inches
Max Print Length39 inches
Max Print Speed10 inches per second
Memory4 MB Flash, 8 MB DRAM
InterfaceParallel, Serial
Media SensorsReflective and transmissive
Media Width0.79 inches to 4.5 inches
Media Length0.38" (9.6 mm) to 39" (991 mm)
Ribbon Width2 inches to 4.33 inches
Power Requirements100-240 VAC, 50/60 Hz
Operating Temperature40°F to 105°F
Storage Temperature-40 to 140°F (-40 to 60°C)
Humidity20 to 85% non-condensing

Related product manuals