Troubleshooting
Printer Diagnostics
Z4Mplus and Z6Mplus User Guide 109
Cancel Self Test
This self test prints a listing of the configuration parameters currently stored in the
printer’s memory. See the labels below. Depending on the options ordered, your label
may look different.
Perform the following procedure to complete the Cancel Self
Test:
1. Turn the printer Off (O).
2. Press and hold CANCEL while turning the printer On (l).
3. Release CANCEL after the DATA light turns off (approximately five seconds).
The configuration may be changed either temporarily (for specific label formats or
ribbon and label stock) or permanently (by saving the new parameters in memory).
See page 22 for further information about the configuration procedure.
Z6Mplus - 300dpi
4
4
Z4Mplus - 200dpi
To Next Page
Loading...
