Zebra Z4Mplus User Manual

Printer Software and Firmware License Agreement
Z4Mplus and Z6Mplus User Guide xv
• Storage/Network Use. You may also store or install a copy of the SOFTWARE
and FIRMWARE on a storage device, such as a network server, used only to
RUN the SOFTWARE and FIRMWARE on your other PRINTERS over an
internal network; however, you must acquire and dedicate a license for each
separate PRINTER on which the SOFTWARE and FIRMWARE is RUN from
the storage device. A license for the SOFTWARE and FIRMWARE may not
be shared or used concurrently on different PRINTERS.
• Reservation of Rights. All rights not expressly granted are reserved by
ZEBRA.
• Accessing Services Using the SOFTWARE and FIRMWARE. Your use of any
service accessible using the SOFTWARE and FIRMWARE is not covered by
this PSFLA and may be governed by separate terms of use, conditions or
notices.
3. RESTRICTIONS.
• You must maintain all copyright notices on all copies of the SOFTWARE and
FIRMWARE.
• Limitations on modification. You may not modify, adapt, translate, or create
derivative works based on this SOFTWARE OR FIRMWARE or the
accompanying documentation.
• Limitations of Reverse Engineering, Decompilation and Disassembly. You
may not reverse engineer, decompile, or disassemble the SOFTWARE or the
FIRMWARE, except and only to the extent that such activity is permitted by
applicable law notwithstanding this limitation.
• Rental. You may not rent or lease or lend the SOFTWARE or FIRMWARE.
• Support Services. ZEBRA may provide you with support services related to
the SOFTWARE and/or FIRMWARE (“SUPPORT SERVICES”), in its
discretion. Use of SUPPORT SERVICES, if any, is governed by the ZEBRA
policies and programs described in the user manual, in “online”
documentation, and/or other ZEBRA provided materials. Any supplemental
SOFTWARE or FIRMWARE code provided to you as a part of SUPPORT
SERVICES shall be considered part of the SOFTWARE and/or FIRMWARE
and is subject to the terms of this PSFLA. With respect to technical
information you provide to ZEBRA as part of the SUPPORT SERVICES,
ZEBRA may use such information for its business purposes, including for
product support and development. ZEBRA will not utilize such technical
information in a form that personally identifies you except to the extent
necessary to provide you with support.

Zebra Z4Mplus Specifications

General

Print Method	Thermal transfer or direct thermal
Resolution	203 dpi
Max Print Width	4.09 inches
Max Print Length	39 inches
Max Print Speed	10 inches per second
Memory	4 MB Flash, 8 MB DRAM
Interface	Parallel, Serial
Media Sensors	Reflective and transmissive
Media Width	0.79 inches to 4.5 inches
Media Length	0.38" (9.6 mm) to 39" (991 mm)
Ribbon Width	2 inches to 4.33 inches
Power Requirements	100-240 VAC, 50/60 Hz
Operating Temperature	40°F to 105°F
Storage Temperature	-40 to 140°F (-40 to 60°C)
Humidity	20 to 85% non-condensing