Zebra Z4Mplus User Manual

62 Z4Mplus and Z6Mplus User Guide
Configuration
Configuration and Calibration Sequence
TEAR OFF Press SELECT to make change.
Adjusting the Tear-off Position: Press PLUS (+) to
increase the value, press MINUS (–) to decrease the value.
Each press adjusts the tear-off position by four dot rows.
Default: +0
Range: –120 to +120
Press SELECT to accept the change.
This parameter establishes the position of the media over the
tear-off/peel-off bar after printing. The label and liner can be
torn off or cut between labels.
PRINT MODE Press SELECT to make change.
Selecting Print Mode: Press PLUS (+) or MINUS (–) to
display other choices.
Default: Tear-off
Selections: Tear-off, cutter, peel-off, rewind
Press SELECT to accept the change.
Print mode settings tell the printer the method of media
delivery that you wish to use. Be sure to select a print mode
that your hardware configuration supports as some
selections displayed are for optional printer features.
Display Shows Action/Explanation

Zebra Z4Mplus Specifications

General

Print Method	Thermal transfer or direct thermal
Resolution	203 dpi
Max Print Width	4.09 inches
Max Print Length	39 inches
Max Print Speed	10 inches per second
Memory	4 MB Flash, 8 MB DRAM
Interface	Parallel, Serial
Media Sensors	Reflective and transmissive
Media Width	0.79 inches to 4.5 inches
Media Length	0.38" (9.6 mm) to 39" (991 mm)
Ribbon Width	2 inches to 4.33 inches
Power Requirements	100-240 VAC, 50/60 Hz
Operating Temperature	40°F to 105°F
Storage Temperature	-40 to 140°F (-40 to 60°C)
Humidity	20 to 85% non-condensing