Zebra ZXP 1 Series - 5.6.9 Feed Cover Sensor

122 Zebra ZXP Series 1 Card Printer Service Manual P1061942-001
5: Replacement Procedures
Procedures
5.6.9 Feed Cover Sensor
Step 1. Locate the Feed Cover Sensor (circled below).
Step 2. With a TORX T7 driver, remove the screw (SCR, PLAST, 2-.25, 2.5 in-lb) that
holds the sensor in place.
Step 3. Cut the cable ties holding the various wires and connectors going to the Main
PCBA.
Step 4. Disconnect the 4-wire sensor plug from connector J8 on the Main
PCBA.
Step 5. Remove the Feed Cover Sensor.
NOTE • This procedure uses Spare Kit # P1031925-053: KIT, FEED COVER SENSOR.