Zebra ZXP 1 Series - 6.2 Cleaning the Printhead

182 Zebra ZXP Series 1 Card Printer Service Manual P1061942-001
5: Replacement Procedures
Procedures
5.6.40 Drive Roller Assembly
Step 1. Locate the Main Drive Roller (circled below).
Step 2. Remove the retaining clip (arrow below) and associated gear pulley.
Step 3. With a TORX T10 driver, remove the two screws (SCR 4-25L, 4.0 in-lb) holding the
side of the support collar to the frame.; circled above.
NOTE • This procedure uses Spare Kit # P1031925-228: KIT, PLATENS FOR PRINT
ENGINE.