5: Replacement Procedures
Procedures
P1061942-001 Zebra ZXP Series 1 Card Printer Service Manual 153
5.6.28 Lid Sensor
Step 1. Locate the Lid Sensor (circled below).
Step 2. With a TORX T7 driver, remove the screw (SCR, PLAST, 2-.25, 2.5 in-lb) holding
the Lid Sensor in place.
Step 3. If not already done, disconnect the Lid Sensor plug from connector J7 on the
Main
PCBA.
Step 4. Remove the Lid Sensor.
NOTE • This procedure uses Spare Kit # P1031925-015: KIT, LID RIBBON ENCODER
SENSOR.
To Next Page
Loading...