To setup a static connection, perform the following steps.
IPv4 static connection is used as an example.
a)
Select Route from the Type drop-down list.
b)
Select IP from the Link Type drop-down list.
c)
Select Static from the IP Type drop-down list.
d)
Specify the IP address, subnet mask, gateway, and DNS server in the IPv4 area.
e)
Specify other parameters as required, and then click Next.
3.
Click Next to open the page, as show in Figure 4.
Figure 4 WiFi Configuration
Table 4 describes the parameters for WiFi configuration.
Table 4 WiFi Configuration
Select Enabled to enable the wireless RF function.
Select the country or region.
Select the authentication type.
The provides the following access authentication modes:
Open System: Authentication is not needed. Any client
with a wireless network card can connect to the wireless
access point.
Shared Key: This mode provides WEP encryption.
WPA-PSK: WPA-PSK is a version of WPA. It uses the
pre-shared key. WPA-PSK is similar with WEP but it is
securer. The data is encrypted before transmission.
WPA2-PSK: It is the second version of WPA-PSK.
To Next Page
Loading...
