Zte ZXHN H108N - Configuring Access Control List; ACL Parameter

33
6.2.4 Configuring Access Control List
The ZXHN H108N device supports ACL function, which is used to permit or block the packets from
the specified MAC address. This procedure introduces how to configure the ACL.
By default, the ACL function for the ZXHN H108N is enabled.
Steps
1. On the navigation tree, click [Network→ WLAN→ Access Control List]. The access control list
configuration page is displayed, see Figure 15.
Figure 15 Access Control List
Table 13 lists the ACL parameters.
Table 13 ACL Parameter
Parameter
Description
Choose SSID
Choose the SSID to configure the ACL.
Mode
There are three options:
 Disabled: Disable the ACL function.
 Block: The wireless device whose MAC address is specified is not
allowed to access the ZXHN H108N device.
 Permit: The wireless device whose MAC address is specified is al-
lowed to access the ZXHN H108N device.
MAC Address
The MAC address of the wireless device
2. Select an SSID from the Choose SSID drop-down list, and then specify other parameters.
3. Click Add to add the MAC address to the access control list.
The ACL is configured.
The MAC address of the wireless device is added to the access control list.