Zte ZXHN H108N - Configuring Service Control; URL Filter Parameter

57
Steps
1. On the navigation tree, click [Security→ URL Filter]. The URL filter configuration page is
displayed, see Figure 38. On this page, you can specify the URL rules to permit or deny the
users to access the specified URL addresses.
Figure 38 URL Filter
Table 27 lists the parameters for URL filter configuration.
Table 27 URL Filter Parameter
Parameter
Description
Enable
Enable the URL filter function
Mode
There are two modes: Discard and Permit.
 Discard: Deny the users to access the specified URL ad-
dresses.
 Permit: Permit the users to access the specified URL ad-
dresses.
URL Address
The URL address that is allowed to be accessed or denied
2. Specify the URL and other parameters, and then click Add.
The URL filter is configured.
Users are permitted or denied to access the specified URL addresses.
7.5 Configuring Service Control
This procedure introduces how to permit or discard the specified inbound access services by
configuring the source IP address range and service type.
Context
By default, you cannot access the device through the WAN interface by FTP or web site.