Zte ZXHN H108N - Configuration Preparation; Configuring TCP;IP; Check the TCP;IP Settings

9
3
Configuration Preparation
3.1 Configuring TCP/IP
This procedure introduces how to configure TCP/IP for the ZXHN H108N device configuration.
Context
To ensure that the ZXHN H108N device accesses the ZXHN H108N successfully, configure the
computer address in the same network segment as the ZXHN H108N address.
The default network settings for the ZXHN H108N are as follows:
 IP address: 192.168.1.254
 Subnet mask: 255.255.255.0
 Default gateway: 192.168.1.254
Steps
1. Configure TCP/IP.
i. In Local Area Connection Properties dialog box, select Internet Protocol (TCP/IP).
ii. Click Properties to open the Internet Protocol (TCP/IP) Properties dialog box.
iii. In the Internet Protocol (TCP/IP) Properties dialog box, select Use the following IP
address. Set IP address, Subnet mask, and Default gateway. For example, set the IP
address to 192.168.1.7, the subnet mask to 255.255.255.0, and the default gateway to
192.168.1.1.
iv. Click OK.
Note:
The settings may change with the network requirements. However, perform the steps above
at the first time.
2. Check the TCP/IP settings.
You can use the Ping command to check the connection between the computer and ZXHN H108N
device.
If pinging the device fails, verify the following:
 The Ethernet cable between the ZXHN H108N device and the computer is not correctly
connected.
 The ZXHN H108N device is not powered on.