Zte ZXHN H108N - Configuring Upnp; DMZ Host Parameters

63
Table 30 DMZ Host Parameters
Parameter
Description
Enable
Enable the DMZ host function.
WAN Connection
The WAN connection that the computer at the LAN side uses to
provide services to the devices at the Internet side.
Enable MAC Mapping
Enable the MAC mapping function.
Enabled the MAC Mapping to configure DMZ Host MAC Address.
DMZ Host IP Address
IP address of the LAN-side host.
DMZ Host MAC Address
MAC address of the LAN-side host.
When enabled Enable MAC Mapping to configure this parameter.
Note:
If the DMZ function is enabled, all the ports of the DMZ host machine are opened to the outside
world, and DMZ host machine will provide services to the outside world through DNAT.
2. Configure the DMZ host parameters, and then click Submit.
8.3 Configuring UPnP
This procedure introduces how to configure UPnP function, which allows the device to dynamically join
a network to obtain an IP address, announce its functions, and know the functions of other devices.
The UPnP function supports zero configuration, invisible networking, and auto discovery of the device
type.
Steps
1. On the navigation tree, click [Application→ UPnP]. The UPnP configuration page is displayed,
see Figure 44.
Figure 44 UPnP
Table 31 lists the UPnP parameters.