Zte ZXHN H108N - Configuring MAC Filter

55
Table 25 IP Filter Parameters
Parameter
Description
Enable
Enable the IP filter function.
Protocal
Select the protocol that needs to filter packets. By
default, it is TCP.
Name
Name of the IP filter rules
Start/End Source IP Address
Range of source IP address
Start/End Destination IP Address
Range of destination IP address
Start/End Source Port
Range of source port
Start/End Destination Port
Range of destination port
Ingress/Engress
Data flow direction
The ingress and egress cannot be the same
 If the ingress is LAN and egress is ADSL, the data
flow is upstream.
 If the ingress is ADSL and egress is LAN, the data
flow is downstream.
Mode
The mode can be Discard or Permit.
2. After the configuration, click Add.
7.3 Configuring MAC Filter
This procedure introduces how to configure MAC filter settings to permit or deny the packets with the
specific MAC addresses to access the Internet.
Context
MAC filter aims at the user-side LAN, that is, the upstream data flow.
Steps
1. On the navigation tree, click [Security→ MAC Filter]. The MAC filter configuration page is
displayed, see Figure 37. On this page, you can specify to discard or permit the data packages
by configuring the MAC address, protocol, and the connection type.