Zte ZXHN H108N - Configuring Ipv4 Default Gateway; Configuring Ipv4 Static Routing

45
6.4.1 Configuring IPv4 Default Gateway
This procedure introduces how to configure one WAN connection as the IPv4 default gateway. All
the user-side devices will access the Internet by using this WAN connection by default.
Steps
1. On the navigation tree, click [Network→Routing(IPv4)→Default Gateway]. The default
gateway page is displayed, see Figure 27.
Figure 27 Default Gateway
2. Select one WAN connection from the WAN Connection drop-down list as the default gateway.
3. Click Submit.
6.4.2 Configuring IPv4 Static Routing
This procedure introduces how to configure the static routing for the specified WAN connection.
Prerequisite
Before configuring static routing, make sure that the WAN connection is created.
Context
The gateway needs to be configured for the Static mode interface or IPoA mode interface during static
routing configuration.
The gateway does not need to be configured for the PPPoA mode interface or PPPoE mode interface
during static routing configuration.
Steps
1. On the navigation tree, click [Network→Routing(IPv4)→ Static Routing]. The static routing
configuration page is displayed, see Figure 28.