Zte ZXHN H108N - Configuring URL Filter; MAC Filter Parameters

56
Figure 37 MAC Filter
Table 26 lists the MAC filter parameters.
Table 26 MAC Filter Parameters
Parameter
Description
Enable
Enable the MAC filter function.
Mode
The mode can be Discard or Permit.
Type
The type can be Bridge, Route, or Bridge+Route.
Protocol
The protocol that the MAC filter rule will be applied to.
Source MAC Address/Destina-
tion MAC Address
MAC address that needs to be filtered.
Both options cannot be null at the same time.
Note:
If you select Permit from the Mode drop-down list, please add the MAC address of your PC first,
otherwise you cannot access the Web configuration page by using the PC that is connected to
the ZXHN H108N device.
2. Configure the MAC filter parameters, and then click Add.
The MAC filter is configured.
The packets with the specified MAC address are denied or allowed to pass through.
7.4 Configuring URL Filter
This procedure introduces how to configure URL filter rules, so that users are permitted or denied to
access the specific URL addresses.