Zte ZXHN H108N - User Configuration

17
Parameter
Description
 WPA/WPA2-PSK: It is a hybrid authentication mode.
Passphrase WPA
Range: 8 ~ 64 characters
Encryption Algorithm WPA
There are three options:
 TKIP:Temporal Key Integrity Protocol
 AES: Advanced Encryption Standard
 TKIP+AES: Adaptive encryption algorithm
WEP Encryption
Enable/Disable WEP Encryption.
WEP Encryption Level
The value can be 64bit or 128bit.
WEP Key Index
The WEP authentication provides four keys.
WEP Key
Use 5 ASCII characters or 10 hexadecimal digits to specify
the WEP value for the 64 bit WEP encryption.
Use 13 ASCII characters or 26 hexadecimal digits to specify
the WEP value for the 128 bit WEP encryption.
4. Click Next to open the User Configuration page, as show in Figure 5.
Figure 5 User Configuration
Table 5 describes the parameters for User configuration.
Table 5 User Configuration
Parameter
Description
Old Password
Input the old password of admin.
New Password
Specify the new password.
Confirmed Password
Confirm the new password.
5. Click Next, then click Finish to finish quick setup.