Zte ZXHN H108N - Configuring 6 In4 Tunnel Connection; 4 In6 Tunnel Connection Parameter

25
This procedure introduces how to configure the 4in6 tunnel connection of DS lite type.
Prerequisite
The IPv6 WAN connection has been created.
Steps
1. On the navigation tree, [Network→ WAN→4in6 Tunnel Connection]. The 4in6 tunnel
connection page is displayed, see Figure 8.
Figure 8 4in6 Tunnel Connection
Table 8 lists the 4in6 tunnel connection parameters.
Table 8 4in6 Tunnel Connection Parameter
Parameter
Description
Tunnel Name
The default is Create Tunnel. Before creating a new
tunnel name, make sure the Create Tunnel option is
selected.
New Tunnel Name
Specify the new tunnel name.
Tunnel Type
At present, only ds-lite is supported.
WAN Connection
Select the IPv6 WAN connection that have been created.
Interface IPv4 Address
Range: 192.0.0.2 ~192.0.0.6
Manual AFTR
Select this option to manually specify the IPv6 address
of the Carrier Grade NAT.
2. Specify the parameters according to the request, and then click Create.
6.1.4 Configuring 6in4 Tunnel Connection
This procedure introduces how to configure 6in4 tunnel connection.