To setup a bridge WAN connection, perform the following steps.
a)
Select Bridge Connection from the Type drop-down list
b)
Specify other parameters as required, and then click Next.
To setup a PPPoE connection, perform the following steps.
a)
Select Route from the Type drop-down list.
b)
Select PPP from the Link Type drop-down list.
c)
Type the user name and password in the PPP area
d)
Select PPPoE from the PPP TransType drop-down list.
e)
Specify other parameters as required, and then click Next.
To setup a PPPoA connection, perform the following steps.
a)
Select Route from the Type drop-down list.
b)
Select PPP from the Link Type drop-down list.
c)
Type the user name and password in the PPP area
d)
Select PPPoA from the PPP TransType drop-down list.
e)
Specify other parameters as required, and then click Next.
To setup a static connection, perform the following steps.
IPv4 static connection is used as an example.
a)
Select Route from the Type drop-down list.
b)
Select IP from the Link Type drop-down list.
c)
Select Static from the IP Type drop-down list.
d)
Specify the IP address, subnet mask, gateway, and DNS server in the IPv4 area.
e)
Specify other parameters as required, and then click Next.
To setup an IPoA connection, perform the following steps.
a)
Select Route from the Type drop-down list.
b)
Select IP from the Link Type drop-down list.
c)
Select DHCP from the IP Type drop-down list.
d)
Specify other parameters as required, and then click Next.
A WAN connection is created.
The newly-created ADSL WAN connection is displayed in the Connection Name drop-down list.
To Next Page
Loading...
