Zte ZXHN H108N - Configuring Ipv4 Policy Routing

46
Figure 28 Static Routing
Table 20 lists the parameters for the static routing configuration.
Table 20 Parameters for Static Routing Configuration
Parameter
Description
WAN Connection
WAN connection for static routing
Network Address
Destination network address
Subnet Mask
Subnet mask
Gateway
Gateway of the network segment which the network interface
belongs to
2. Select one WAN connection from the WAN Connection drop-down list, and then specify other
parameters.
3. After the configuration, click Add.
6.4.3 Configuring IPv4 Policy Routing
This procedure introduces how to configure the policy routing for the specified WAN connection.
Prerequisite
Before configuring policy routing, make sure that the WAN connection settings are complete.
Context
Policy routing is a routing rule. When it is configured, the packets are forwarded based on the routing
policy. The ZXHN H108N supports packet forwarding based on the DSCP, source or destination IP
address, protocol, source port number, or source MAC address.
Steps
1. On the navigation tree, click [Network→Routing(IPv4)→ Policy Routing]. The policy routing
configuration page is displayed, see Figure 29.