Steps
1.
On the navigation tree, click [Application→ SNTP]. The SNTP configuration page is displayed,
see Figure 54.
Figure 54 SNTP
Table 35 lists the SNTP parameters.
Table 35 SNTP Parameters
Select the WAN connection
Primary NTP Server Address
IP address/realm name of the primary NTP server
Secondary NTP Server
Address
IP address/realm name of the secondary NTP server
Interval of time synchronization
Unit: second
Enable Daylight Saving Time
Enable the Daylight Saving Time.
2.
Configure the SNTP parameters, and then click Submit.
8.9
IGMP
This section includes the following:
Configuring WAN connection
To Next Page
Loading...
