Zte ZXHN H108N - Configuring SSID Settings

30
Parameter
Description
Transmitting Power
Select the transmitting power as required.
QoS Type
There are three QoS types:
 Disable
 WMM
 SSID
The default QoS type is WMM.
RTS Threshold
Specify the request to send threshold for a packet. When a
packet exceeds this value, the device sends the RTS value to the
destination point for negotiation. The default is 2347.
DTIM Interval
Range: 1 ~ 5
Default: 1
2. Select Enabled from the Wireless RF Mode drop-down list to enable the wireless transmission
function, and then select the transmission mode. For example, select IEEE 802.11n Only from
the Mode drop-down list, and specify the other parameters according the request.
3. After the configuration, click Submit.
6.2.2 Configuring SSID Settings
The ZXHN H108N device supports four SSIDs and each SSID supports up to 32 subscribers.
This procedure introduces how to configure the SSID settings.
Steps
1. On the navigation tree, click [Network→ WLAN→ SSID Settings]. The SSID setting page is
displayed, see Figure 13.
Figure 13 SSID Settings
Table 11 lists the SSID parameters.