Zte ZXHN H108N - Configuringipv6 Policy Routing

50
Table 22 Parameters for the IPv6 Static Routing
Parameter
Description
WAN Connection
WAN connection for IPv6 static routing
Prefix
The prefix is consistent with the network segment of the IPv6
interface.
Gateway
The gateway is the next hop address when this routing interface
transfers the packets of different network segment.
2. Configure the parameters, and then click Add.
6.5.3 ConfiguringIPv6 Policy Routing
This procedure introduces how to configure the IPv6 policy routing for the specified WAN connection.
Prerequisite
Before configuring IPv6 policy routing, make sure that the IPv6 WAN connection settings are
complete.
Context
Policy routing is a routing rule. When it is configured, the packets are forwarded based on the routing
policy. The ZXHN H108N supports packet forwarding based on the DSCP, source or destination IP
address, protocol, source port number, or source MAC address.
Steps
1. On the navigation tree, click [Network→Routing(IPv6)→ Policy Routing]. The IPv6 policy
routing configuration page is displayed, see Figure 33.