6.3.4
Configuring DHCP Port Service
This procedure introduces how to disable the DHCP service for the specified interface or SSID when
the global DHCP function is enabled.
Prerequisite
Before configuring DHCP port service, make sure that the global DHCP service is enabled.
Steps
1.
On the navigation tree, click [Network→ LAN→ DHCP Port Service]. The DHCP port service
configuration page is displayed, see Figure 22.
Figure 22 DHCP Port Service
2.
Select the LAN interface or SSID whose DHCP function you want to disable.
3.
Click Submit.
The DHCP function is disabled on the specified interface or SSID.
The devices that are connected to the specified LAN interface or use the SSID will not be assigned
the IP addresses.
6.3.5
Configuring IPv6 Static Prefix
This procedure introduces how to configure the IPv6 static prefix.
Context
The prefix is distributed by the RA or DHCPv6 server. Only the GUA prefix with the length between
48 and 64 is supported. The valid life time should be longer than the preferred life time.
Steps
1.
On the navigation tree, click [Network→ LAN→ Static Prefix], see Figure 23.
To Next Page
Loading...
