Zte ZXHN H108N - Configuring Committed Access Rate; Configuring SNTP

73
8.7.4 Configuring Committed Access Rate
This procedure introduces how to configure the committed access rate for the specified LAN interface
or SSID.
Prerequisite
Before configuring committed access rate, make sure that:
 The basic QoS configuration is completed.
 The global committed access rate function is enabled.
Steps
1. On the navigation tree, click [Application→ QoS→ Committed Access Rate]. The committed
access rate configuration page is displayed, see Figure 53.
Figure 53 Committed Access Rate
2. Select the WAN interface, LAN interface or SSID from the DevIn drop-down list, enable the
committed access rate function, and then configure the rate.
3. Click Add.
The committed access rate for the specified LAN interface or SSID is configured.
8.8 Configuring SNTP
This procedure introduces how to configure SNTP to synchronize the device time with the server time.