Chapter 2 Hardware
VMG/EMG/AM/DM/GM Series User’s Guide
54
Note: If your Zyxel Device supports both 2.4 GHz and 5 GHz wireless networks, the connection
to the 2.4 GHz wireless network has priority.
To turn off the wireless network, press the WiFi button. The WLAN/WPS LED turns off when the wireless
network is off.
See the Quick Start Guide to see how long you need to press the WiFi and WPS buttons on the Zyxel
Device.
2.2.3 The RESET Button
If you forget your password or cannot access the Web Configurator, you will need to use the RESET
button to reload the factory-default configuration file. This means that you will lose all configurations
that you had previously. The password will be reset to the factory default (see the device label), and the
LAN IP address will be “192.168.1.1”.
1 Make sure the POWER LED is on (not blinking).
2 To set the device back to the factory default settings, press the RESET button or until the POWER LED
begins to blink and then release it. When the POWER LED begins to blink, the defaults have been
restored and the device restarts.
See the Zyxel Device Comparison Table to see how long you need to press the RESET button on the Zyxel
Device.
2.3 Wall Mounting
Please refer to the following example for the wall mounting procedures of the following Zyxel Device:
• VMG3312-T20A
Note: For other Zyxel Devices that have a wall-mounting feature, please refer to Quick Start
Guides.
Do the following to attach your Zyxel Device to a wall.
1 Drill into a wall two holes 3 mm ~ 4 mm (0.12" ~ 0.16") wide, 20 mm ~ 30 mm (0.79” ~ 1.18”) deep and
126mm apart. Place two screw anchors in the holes.
2 Screw two screws with 6mm ~ 8 mm (0.24" ~ 0.31") wide heads into the screw anchors. Do not screw the
screws all the way in to the wall; leave a small gap between the head of the screw and the wall. The
gap must be big enough for the screw heads to slide into the screw slots and the connection cables to
run down the back of the Zyxel Device.
To Next Page
Loading...
Need help?
General
