Chapter 35 Product Specifications
N4100 User’s Guide
258
RJ-45 Ethernet Ports
The following table describes the types of network cable used for the different
connection speeds.
Note: Make sure the Ethernet cable length between connections does not exceed 100
meters (328 feet).
WAN Port
The following figure and table describe the Ethernet cable pin assignments for the
WAN port.
Figure 124 WAN Port Cable Pin Assignments
RFC 1631 IP Network Address Translator (NAT)
RFC 1661 The Point-to-Point Protocol (PPP)
RFC 1723 RIP-2 (Routing Information Protocol)
RFC 2236 Internet Group Management Protocol, Version 2.
RFC 2516 A Method for Transmitting PPP Over Ethernet (PPPoE)
RFC 2766 Network Address Translation - Protocol
IEEE 802.1D Standard for Local and Metropolitan Area Networks: Media
Access Control (MAC) Bridges
IEEE 802.1x Port Based Network Access Control.
Microsoft PPTP MS PPTP (Microsoft's implementation of Point to Point Tunneling
Protocol)
Table 69 Standards Supported (continued)
STANDARD DESCRIPTION
Table 70 Network Cable Types
SPEED NETWORK CABLE TYPE
10 Base-TX 100Ω 2-pair UTP/STP Category 3, 4 or 5
100 Base-TX 100Ω 2-pair UTP/STP Category 5
To Next Page
Loading...
