ABB AC 800M

Configuring EtherNet/IP Device Section 4 Configuration
138 9ARD000014-600 A
Electronic
Key Product
Ty p e
Enum - 0 1 Editable Criteria that can be specified by user
for EtherNet/IP to accept connection
from CI873 only when Product Type
of EtherNet/IP configured in Control
Builder matches with the Product
Type of EtherNet/IP device in the
network.
Values are:
Enable Keying, Disable Keying
Upon modification, connection
between EtherNet/IP and CI873 gets
disconnected and connected again.
Electronic
Key Product
Code
Enum 0 1 Editable Criteria that can be specified by user
for EtherNet/IP to accept connection
from CI873 only when Product code
of EtherNet/IP configured in Control
Builder matches with the Product
code of EtherNet/IP device in the
network.
Values are:
Enable Keying, Disable Keying
Upon modification, connection
between EtherNet/IP and CI873 gets
disconnected and connected again.
Table 23. Settings for EtherNet/IP Device Unit (Continued)
Parameter Data Type Unit Min Max
Editable
/Read
Only
Description