ABB AC 800M

Appendix A Troubleshooting EDS File
9ARD000014-600 A 239
65 The enumrange
parameter is
currently in use
This message
comes when user
clicks delete a
parameter which is
been referred by a
Channel.
EtherNet/IP/
DeviceNet
Continue the import
with this message
after specifying valid
enum range
parameter.
66 Overflow value
should be greater
than max
When overflow
value entered is
less than the
maximum value
EtherNet/IP/
DeviceNet
Continue the import
with this message
after specifying valid
overflow value for the
parameter.
67 Underfolw value
should be less than
Min
when underflow
value entered is
more than the
minimum value.
EtherNet/IP/
DeviceNet
Continue the import
with this message
after specifying valid
underflow value for
the parameter.
68 Min value should be
in between Max and
Underfolw
When minimum
value entered is not
in the range of
maximum and
underflow value.
EtherNet/IP/
DeviceNet
Continue the import
with this message
after specifying valid
minimum value for the
parameter.
69 Max value should be
in between Min and
Overfolw
when maximum
value entered is not
in the range of
minimum and
overflow value.
EtherNet/IP/
DeviceNet
Continue the import
with this message
after specifying valid
maximum value for
the parameter.
Table 41. Messages - Import of EDS Files (Continued)
Sl
No
Message Reason
Applicability
Based on Device
Classification
Additional
Information and
Workaround