ABB ACS180 - Page 251

Parameters 251
41.47 Set 2 wake-up
deviation
See parameter 40.47 Set 1 wake-up deviation.0.00 PID
customer
units
41.48 Set 2 wake-up delay See parameter 40.48 Set 1 wake-up delay.0.50 s
41.49 Set 2 tracking mode See parameter 40.49 Set 1 tracking mode. Not selected
41.50 Set 2 tracking ref
selection
See parameter 40.50 Set 1 tracking ref selection. Not selected
41.51 Set 2 trim mode See parameter 40.51 Set 1 trim mode. Off
41.52 Set 2 trim selection See parameter 40.52 Set 1 trim selection. Speed
41.53 Set 2 trimmed ref
pointer
See parameter 40.53 Set 1 trimmed ref pointer. Not selected
41.54 Set 2 trim mix See parameter 40.54 Set 1 trim mix.0.000
41.55 Set 2 trim adjust See parameter 40.55 Set 1 trim adjust.1.000
41.56 Set 2 trim source See parameter 40.56 Set 1 trim source. PID output
41.56 Set 2 increase
prevention
See parameter 40.58 Set 1 increase prevention. No
41.59 Set 2 decrease
prevention
See parameter 40.59 Set 1 decrease prevention. No
41.60 Set 2 PID activation
source
See parameter 40.60 Set 1 PID activation source. On
41.79 Set 2 units See parameter 40.79
Set 1 units.150
41.80 Set 2 PID output min
source
Selects the source for set 2 PID output minimum. Set2 output
min
None None. 0
Set2 output min 41.36 Set 2 output min.1
41.81 Set 2 PID output max
source
Selects the source for set 2 PID output maximum. Set2 output
max
None None. 0
Set2 output max 40.47 Set 2 output max 1
41.89 Set 2 setpoint
multiplier
See parameter 40.89 Set 1 setpoint multiplier.1.00
41.90 Set 2 feedback
multiplier
Defines the multiplier k used in formulas of parameter
41.10 Set 2 feedback function. See parameter 40.90 Set 1
feedback multiplier.
1.00
No. Name/Value Description Default
FbEq 16
ACS180 FW.book Page 251 Tuesday, March 9, 2021 2:25 PM