5.9 Gears
5.9.1 Replacing the axis-1 gearbox
Location of the gearbox
The gearbox is located as shown in the figure.
xx2000000403
Summary of the replacement procedure
This is a brief summary of the replacement procedure, containing the major actions
to be performed.
1 If installed in an inverted position (option 3317-1): Lift down the robot to floor
standing and secure onto four support legs.
2 If installed floor mounted: Lift the robot and secure onto four support legs.
3 Drain the axis-1 gearbox.
4 Remove the cabling from the base.
5 Remove the axis-1 motor.
6 Remove the complete arm system (complete robot excluding the base and
axis-1 gearbox) as an assembly.
7 Replace the axis-1 gearbox.
Continues on next page
Product manual - IRB 5720 415
3HAC079195-001 Revision: A
© Copyright 2022 ABB. All rights reserved.
5 Repair
5.9.1 Replacing the axis-1 gearbox
To Next Page
Loading...
