9.7 Special tools
General
All service instructions contain lists of tools required to perform the specified
activity. The required tools are a sum of standard tools, defined in the section
Standard toolkit on page 596, and of special tools, listed directly in the instructions
and also gathered in this section.
Special tools
Note
If the replacing procedure is not listed in the table below, only standard tools are
needed for the procedure.
Continues on next page
Product manual - IRB 5720 597
3HAC079195-001 Revision: A
© Copyright 2022 ABB. All rights reserved.
9 Reference information
9.7 Special tools
To Next Page
Loading...
